This is a voltage divider module which reduces the input voltage by a factor of 5. It enables monitoring of higher voltages (up to 25V) with a microcontroller that has an analogue input range of 0-5V. The module includes screw terminals for easy and secure connection and is based on the resistive voltage divider design. The minimum voltage that can be detected is 0.02445V and the resolution is 0.00489V. The module can be connected to an expansion board (such as Arduino) through a 3P connector and can also be used with an IICLCD1602 LCD to display the voltage. The divider ratio is 5:1 and the resistor tolerance is 1%.

Specification:

Voltage input range: DC 0-25 V
Voltage detection range : DC0.02445V – 25V
Voltage analog resolution : 0.00489 V
Output Interface: “ ” connected 5/3.3V, “-” connected GND, “s” connected Arduino AD pins
DC input interface: red terminal positive with VCC, negative with GND
By 3P connector, connect this module with the expansion of the Arduino board, not only makes it easier for you to detect the voltage battery but can also use the IICLCD1602 LCD to display voltage.
Divider ratio: 5:1
Resistor Tolerance: 1%
Max input voltage: 25V
Resistor Value: 30K/7.5K Ohm
Features:
You can also use the IICLCD1602 LCD to display voltage.
By 3P connector, connect this module with the expansion of the Arduino board, it makes it easier for you to detect battery voltage.