PISTEP2Q - STEPPER MOTOR CONTROL BOARD

- This neat little board plugs directly into the Raspberry Pi GPIO header and provides 2 or 4 connectors for small stepper motors.
- Fully Assembled - No Soldering Required
- Raspberry Pi Zero Form Factor - works with all versions of Raspberry Pi with 40pin GPIO connector
- Works with UniPolar (5-pin) stepper motors. Not with Bipolar (4-pin) motors.
- Stepper motors and Raspberry Pi not included
- Various Power Options:
Powered from the Raspberry Pi 5V
From the 2-pin Terminal (whatever voltage is required for the motors)
Micro-USB - 5V only
- Pinout is simple:
Physical pins 11, 12, 13, 15 for Motor A (GPIO 17, 18, 27, 22)
Physical pins 16, 18, 22, 7 for Motor B (GPIO 23, 24, 25, 04)
Physical pins 33, 32, 31, 29 for Motor C (GPIO 13,12,6,5)
Physical Pins 38, 37, 36, 35 for Motor D (GPIO 20,26,16,19)
Each pin has an associated white LED so you can see the stepper signals going through