Hands Gesture Control Robo Car Kit
AEDÂ 285.00
In stock
Only 10 left


Guarantee safe & secure checkout
Welcome to the Hand Gesture Control Car Kit! In this kit you will build a wireless robot car
that moves in response to the tilt of your hand no buttons, no joysticks, just pure motion.
This project teaches you how two Arduino boards communicate wirelessly using Bluetooth
Low Energy (BLE), how an accelerometer measures tilt, and how motor driver circuits
control real DC motors.
• How BLE (Bluetooth Low Energy) wireless communication works
• Reading tilt data from an ADXL345 accelerometer sensor
• Controlling DC motors with an L298N motor driver
• Writing and uploading code to Arduino Nano and Arduino Uno
• Obstacle detection using an ultrasonic sensor (HC-SR04)
• Building a master/slave communication system
Below is the complete list of components included in this kit. Check each item before
starting.
| # | Component | Qty | Notes |
| 1 | Arduino Nano (with USB cable) | 1 | Master controller - Gontrol unit |
| 2 | Arduino Uno R3 (with USB cable) | 1 | Slave controller - Car unit |
| 3 | JDY-09 BLE Module | 2 | One for each Arduino |
| 4 | ADXL345 Accelerometer | 1 |
Tilt/roll sensor - mounted on glove |
| 5 | L298N Motor Driver Module |
1 |
Controls the two DC motors |
| 6 | DC Gear Motors (with wheels) | 2 | Drive the robot car |
| 7 | HC-SR04 Ultrasonic Sensor | 1 | Obstacle detection on car |
| 8 | 9V Battery + connector | 1 | Power for master unit |
| 9 | AA Battery + holder | 6 | Power for the motors |
| 10 | Jumper Wires (M-M, M-F) | 1 set | 20 cm length |
| 11 | Breadboard (mini) | 2 | One per unit |
| 12 | Glove | 1 | Mount components on hand |
|
Stock |
Shipping Method |
ETA |
Cost |
|
|
Available |
Self Pickup |
1 Day |
Free |
|
Available |
Urban Areas in UAE |
1 - 2 Days |
AED 15 / Free Above AED 100 |
|
Available |
Remote Areas in UAE |
2 - 3 Days |
AED 15 / Free Above AED 100 |
|
Available |
International |
4 - 7 Days |
AED 180 / $ 49 |
|
Pre-Order |
General |
4-5 Weeks |